How to Install Tongue and Groove Siding. How to Install Tongue and Groove Siding.
By Robert Robillard on How To. Cedar Tongue And Groove Siding Install. On a recent shed project we used Western Red tongue and groove cedar as our siding choice. We chose cedar for the following reasons: Aesthetics: Western Red Cedar tends to compliment any architectural design. It enhance the beauty and elegance of your home and can be used as siding, decking, moulding, windows, trim, doors, posts, beams, paneling, outdoor projects, interiors and saunas.
Finish: Western Red Cedar is virtually pitch and resin free, the wood easily accepts a range of finishes, from fine oils and stains, to solid coatings and paint. Versatility: Western Red Cedar tongue and groove boards can be installed horizontally, vertically or diagonally. The joints between adjoining pieces are usually v- shaped and the surface usually has a smooth and a rough face. Insect And Rot Resistance: Western Red Cedar’s unique aroma comes from naturally occurring thujaplicinsin its heartwood. These compounds resist moisture and are toxic to decay- causing fungi and insects. We installed this tongue and groove siding vertical.
Installing Tongue And Groove Car Siding Paneling
Cedar Tongue And Groove Siding Install. On a recent shed project we used Western Red tongue and groove cedar as our siding choice. We chose cedar for the following.
The first step was to use a level and install the first piece plumb. We started at a corner since all four corners were going to have corner board trim installed.[Note – Photo example.
The actual installed board would be closer to the corner]How to Install Tongue and Groove Siding. We used 1 1/4″ long 1/4″ galvanized staples to install this cedar. The stales are installed every 1. This is called “blind nailing.” the only location that we installed fasteners in the face of the cedar was at the top where a trim board was covering it. When blind nailing, the nail is sent into the groove at roughly a 4. The nail can be started with a normal carpenter’s hammer, and then made flush with the surface of the groove by means of a nail set.
Installing Tongue And Groove Car Siding For Sale
![Installing Tongue And Groove Car Siding Pine Installing Tongue And Groove Car Siding Pine](http://s-media-cache-ak0.pinimg.com/736x/4b/58/9c/4b589c80ec96f421c0a42433cdb9e61f.jpg)
On the side of the building the roof angle was three pitch so we knew we had to cut our tongue and groove cedar boards at a 1. Another way of determining the roof angle would be to use a bevel tool to copy the angle and transfer it to your saw. Match the saw to your bevel, cut a scrap board and test the fit. Instead of cutting and measuring each angled board I cut multiple boards and laid them out on a surface. By doing this I was able to easily continue the boards angle by measuring the long point of the board I just cut and marking a new board at it’s “short” point and cutting that.
- We are building a new home with vaulted ceilings in the living room. We will be installing 8" tongue-and-groove planks on the ceiling and can't decide t.
- I am installing tongue and groove siding for the first time. When I'm done, how do I hide the uneven tongue and groove piece at the start and the end of where I am.
For example: I had just cut this board. The long point [longest side of the board] is 7. I measure to cut the next, adjoining board I will mark the short point at 7. This is an easy way to figure out and cut all of the boards needed and then go install them all at once. It saves steps in measuring and walking back and forth to the saw. If you enjoyed this post, make sure you subscribe to my RSS feed or receive updates via email↑ Grab this Headline Animator.